Ahresty Techno Service Corporation

Used for injection measurements of die casting machines.
Can also be used for machines that are not equipped with a measurement system.
Alternative measurement with an aging measuring device can be performed at a lower cost.
Can be used to set casting conditions at the time of trial casting.
Normalcy or abnormality can be evaluated during casting.
Can be used for traceability of quality records.

For IM-12V
Measurement of spray pressure, cooling water pressure, air pressure and hydraulic circuit pressure.

Die temperature during casting can be measured.
By means of a locating spring, the size can be freely changed to fit the hote.
The spring pressing the top against the die, temperature can be exactly measured, without being affected by vibration or rust.
The same thermocouple can be used for many different holes regardless of hole length.
For installation on the die, one-touch metal fitting or G 1/8 thread fitting are available.
Connecting is made by connector method facilitating connect/disconnect.
The sheath remaining outside the die can be bended.
Connector uses water-proof boot, enabling measurement in bad conditions.